Roof Replacement in Chesterland, OH September 2026
New GAF architectural shingle roof on a long Chesterland ranch, finished September 2026. Plywood for soft spots in the deck was part of the plan from the start, along with new metal everywhere water can get in.
- Chesterland, Ohio
- September 2026
- Roof Replacement
- 7 finished photos
Finished job photos
Chesterland project gallery


Long slope of new shingles above the gutter in Chesterland 
Ridge vent and box vent at the end of the Chesterland roof 
Eave edge with new drip edge along the gutter in Chesterland 
New step and counter flashing at the chimney in Chesterland 
Chimney flashing turned out onto the shingles in Chesterland 
Ridge cap leading to the chimney in Chesterland
Tap any photo to open it full size.
Scope
What we did
- Replaced soft decking with new plywood before shingling
- New drip edge so eave water goes into the gutter
- Step and counter flashing on the brick chimney
- GAF ridge vent plus can vents to move attic air
- Swept the yard with a magnet for nails before we left
At a glance
- Roof
- GAF architectural shingles, long ranch with a brick chimney
In the photos
What you are looking at
Some roofs hide rot until the shingles come off. The estimate for this house set aside plywood for soft spots, so the homeowner knew up front that any bad wood would be cut out and replaced, not shingled over. Once the deck was solid, synthetic underlayment went down, with ice and water barrier at the eaves and around every opening.
A long ranch has a lot of eave. Drip edge is the metal strip along that edge, and it does two jobs: it holds the shingle edge straight and it kicks water into the gutter instead of letting it curl back under onto the wood. Every foot of eave on this house got new drip edge.
The brick chimney got new step flashing up the sides and counter flashing over it. The old pipe boots came off too, since the estimate called for complete flashing replacement, and open metal valleys went in where the roof sections meet.
For airflow, a GAF ridge vent runs along the peak with can vents working alongside it. GAF starter strip and hip and ridge caps finish the edges. If you're in Chesterland and wondering what's under your shingles, call or text us. We'll get on the roof, photograph what we find and show you. No cost.



