Before snow covers the roof, save a small set of photos that shows its visible condition and the rooms beneath it. Take them from safe, accessible locations. The purpose is to give a future inspection a dated reference, especially if you notice a leak or loose component later in the winter.
These photos do not certify the roof’s condition or establish when hidden damage occurred. A clear baseline simply helps you and the contractor compare what was visible before and after a change.
1. A wide view of the front roof
Stand on stable ground where the roof can be seen without positioning yourself beneath a loose component. Include the full roofline and part of the house. A wide image shows where a chimney, valley, or dormer sits relative to the concern you may photograph later.
Keep the original file. Cropping can make a detail easier to discuss, but the uncropped image preserves location and context. If you take another picture in January, use approximately the same position when conditions make that safe.
Do not climb a wall, vehicle, or ladder to improve the angle. The parts you cannot see belong on an inspection request.
2. A view of the rear or shaded slope
Photograph the back roof from an accessible part of the yard. Note if a tree, addition, or neighboring structure blocks your view. A partially visible slope should be labeled as partial instead of described as checked.
If you can see a low roof over a porch or addition from an ordinary window, take the photo from inside. Keep the window position and room in the filename or accompanying note. Do not step onto the lower roof.
Different angles can show different conditions, but do not interpret lighting differences as damage. A shaded area appearing darker in November is an observation for comparison, not a diagnosis.
3. The gutter and downspout at a known trouble spot
If one gutter has overflowed or one downspout has come loose, record that specific location. Include the outlet and visible discharge area where possible. A close-up of a separated joint is more useful when paired with a wider image identifying the side of the house.
Note whether the problem is active, was repaired, or is awaiting service. If you already have a contractor’s before-and-after photos, keep them together with yours.
Do not put your phone into a gutter or pull apart a connection to photograph the inside. The contractor can document inaccessible details with the equipment and access suited to the job.
4. A ceiling with an old or recently repaired stain
Photograph the entire ceiling area and then the mark. Include a simple note such as “dry mark present before November” or “repair completed October 20; interior finish not yet repainted.” Use actual dates where you have them.
That context helps prevent an old stain from being mistaken for a new event. It also helps you recognize when the edge expands or a previously dry area becomes wet.
If the ceiling is sagging or water is near electrical fixtures, keep away from the area and seek professional help. Documentation can wait when taking the picture would put you beneath a hazard.
5. The roof details a professional has already documented
Ask for copies of photos from a recent inspection or repair, especially details you cannot see from the ground. These might include flashing, a repaired penetration, or exposed decking photographed during work. Keep the contractor’s captions so you know what the image actually shows.
GAF’s roof-leak guidance describes several possible leak sources. A photo showing one repaired component is useful, but it should not be treated as proof that every possible entry point was examined.
If a photograph has no location, ask the contractor to identify it. “Rear slope, plumbing vent above upstairs bathroom” is far more helpful than “roof picture 14.”
6. The paperwork that identifies the roof
Take readable photos or scans of the product label, installation record, repair invoice, and relevant warranty information you already have. Include all pages, not only the page with the largest coverage number. Save the original documents as well.
If the house came with an older roof and incomplete records, write down what is known and what remains uncertain. A seller’s estimate of the installation year should remain an estimate. Do not convert it into a verified date because your folder needs a label.
Keep personal and financial information out of the images you send unless it is relevant to the contractor’s request. You can share a product page without sharing an unrelated payment account number.
Give the folder a simple structure
Use one folder named for the property and season, with subfolders for exterior photos, interior observations, and contractor records. Put a short note at the top listing known concerns and pending work. Back it up somewhere accessible if your phone stops working.
You can name files by location and date: “2026-11-16-rear-gutter” is easier to find than an uncaptioned screenshot. Preserve the original timestamp and avoid editing images in ways that conceal what was visible.
When a winter problem appears, send the relevant pair of pictures instead of the whole camera roll. Explain what changed and when you first noticed it. Avoid guessing the cause or the exact date a hidden problem began.
If you need current roof photos from places you cannot safely see, request an inspection from Rocket Roofing. Ask which areas were examined, which were inaccessible, and which images should stay in your roof file for the winter.
